Bladon Micro Turbine: home
Worked examples

Generator running cost examples by region

Worked examples using the same method as our TCO calculator. Your own figures will differ: open the calculator to enter them.

Updated

Assumptions

  • The Bladon litres default to the diesel litres multiplied by the datasheet fuel ratio at 75% load against a comparable diesel genset: MTP40 0.91 (7.47 L/h against 8.2 L/h, the mean of the Cummins C44D5 datasheets; MTP40 datasheet Rev. 40202609) and MTG12 1.21 (4.3 L/h against 3.55 L/h, the mean of the Cummins C17D5 at 3.4 L/h and the Kohler K16 at 3.7 L/h). If your diesel is oversized and runs lightly loaded, your Bladon figure will be lower: edit it to match your site.
  • The rest of the saving comes from running cheaper fuels (typically kerosene or paraffin), needing one service visit per year instead of monthly visits, and losing far less fuel to theft, because kerosene and mixed fuels have little resale value.
  • The saving depends on the diesel-to-kerosene price gap in your market, and we will model it for your site.
  • Compares operating cost: fuel, fuel lost to theft, and scheduled service. Capital cost is excluded from the operating comparison and is used only to derive the payback period, where you enter it.
  • Theft is entered separately for each side, as a share of the fuel delivered to that side, so the litres you enter are the litres actually burned. The Bladon default is low but not zero: the blended and low-value fuels the turbine runs cannot be dropped into a vehicle, used in another generator, or resold, so there is no route to sell what is taken, which removes most of the incentive without eliminating it. Either figure can be set to zero.
  • Assumes 365 days/year continuous operation at the rates you enter.
  • Replacement is now modelled. At 8,760 run hours a year, a 45,000 hours design life is reached at 5.1 years, and a diesel genset at 15,000 to 25,000 hours is reached two to four times inside the same period. The model counts whole replacements only, and it costs them at the capital figures you enter, so it shows nothing on this line until you enter them.
  • Replacement assumes the unit is replaced rather than overhauled, which is normal practice at this size. If your operation overhauls instead, enter the overhaul cost in place of the capital cost.
  • Figures are indicative. For a site-specific TCO accounting for your fuel logistics, theft exposure and load profile, talk to sales.